N54 Knuckle Dent Rods

Many dents on brass instruments can be removed easily using these knuckle tools. The tools are designed so that they can get into many “hard to reach” areas, then dents can be pushed out without unnecessary hammering or over working the brass. This cuts down on the possibility of cracking or stretching the metal. With these tools you reverse the action of the impact which caused the dent. In other words, you push the metal out instead of in.
This set is used on all valve ports and other small diameter crooks.
It consists of five 1/4” (6.4mm) rods, running in varying degrees from a straight rod to a 90° (right angle).
This set is used with the N80A Dent Rod Ball Set. Each rod has a threaded end which will receive a 5/16” (7.9mm), 3/8” (9.5mm) or a 7/16” (11.1mm) ball. By interchanging the ball you multiply the various configuration of the rods and balls to make a total of 15 different tools at your disposal. Use N80AS.We suggest getting 5 extra N54A’s for custom bending.

N54S Knuckle Dent Rods, Set of 5
N54A Indv. Knuckle Dent Rod
N54B Indv. Knuckle Dent Rod
N54C Indv. Knuckle Dent Rod
N54D Indv. Knuckle Dent Rod
N54E Indv. Knuckle Dent Rod

Also Available:
N55 Knuckle Dent Rods

Related Products